10
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
TREADMILL
OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
11
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE YOU
BEGIN
TREADMILL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
ASSEMBLY
STEP 2
(CONTINUED)
FLAT WASHER (E)
BOLT (D)
RIGHT CONSOLE MAST
MAIN FRAME
WAVY WASHER (F)
ELEVATION FRAME
PRE-ATTACHED NUT
PRE-ATTACHED BOLT
CONSOLE CABLES
FOOT LOCK LATCH
RIGHT LINKAGE ARM
PRE-ATTACHED
TEFLON WASHER
1
3
2
NOTE:
If you have attempted to
move the treadmill from the box
and the machine has sprung
open and cannot be assembled,
refer to the troubleshooting
section in order to restore the
treadmill to its proper position.
Insert 1
BOLT (D)
and 1
FLAT WASHER (E)
through
RIGHT CONSOLE MAST
followed by 1
WAVY WASHER
(F)
and attach to
MAIN FRAME.
Unscrew
PRE-ATTACHED NUT
and remove from
RIGHT
LINKAGE ARM
and discard. Carefully move
RIGHT
LINKAGE ARM
and
PRE-ATTACHED
TEFLON WASHER
into position and attach to
ELEVATION FRAME
.
NOTE: While holding
RIGHT CONSOLE MAST
in the
upright position, tighten
PRE-ATTACHED BOLT
using
T-wrench to attach
RIGHT LINKAGE ARM
.
Cut band holding
FOOT LOCK LATCH
assembly. Lift the
RUNNING DECK
until lock latch on side of treadmill is
fully engaged.
Remove
CONSOLE
from box and place out of the way.
Lower the treadmill
RUNNING
DECK
from the folded
position by stepping on
FOOT
LOCK LATCH
on lower
right side.
A
B
C
D
E
LOCK LATCH PIN (G)
Qty: 1
WAVY WASHER (F)
29 mm
Qty: 1
BOLT (D)
Qty: 1
FLAT WASHER (E)
27 mm
Qty: 1
HARDWARE BAG 2 CONTENTS:
ASSEMBLY
STEP
CONSOLE
CABLES
BOLTS (A)
FLAT WASHERS (H)
CONSOLE
BOLT (A)
15 mm
Qty: 4
FLAT WASHER (H)
16 mm
Qty: 4
HARDWARE BAG CONTENTS:
Open
HARDWARE BAG
.
With running deck in lowered position, pull
CONSOLE CABLES
through right side handlebar.
Slide
CONSOLE
onto the top brackets of the
UPRIGHT MASTS
.
Connect
CONSOLE CABLES,
carefully tucking wires in masts to avoid damage.
To connect
CONSOLE
to
UPRIGHT MASTS
, place 4
BOLTS (A)
and 4
FLAT WASHERS (H)
into
holes in
CONSOLE
and tighten. Partially thread all bolts before completely tightening any
one bolt.
A
B
C
D
E
* NOTE:
Be
careful not to
pinch any
wires while
attaching the
console.
T401_Rev.2.3.indd 10-11
7/1/08 8:22:13 AM
