INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
TREADMILL
OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
DO NOT CUT STRAPS UNTIL STEP 1-E!*
Disassemble box and remove the
cardboard packaging that is not beneath the treadmill. Do not attempt to lift the
treadmill at this time. Remove plastic wrap from console masts.
NOTE:
During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before
completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware.
Any grease, such as lithium bike grease is recommended.
Open
HARDWARE BAG 1
.
Lift
LEFT CONSOLE MAST
into
upright position. Be sure to hold
the console mast firmly, as it
will not stay in the upright
position on it’s own.
Move
LEFT SIDE LINKAGE ARM
into position. Insert
BOLT (A)
and tighten.
Repeat on the right side.
Now cut the banding straps and
remove remaining packaging
material.*
Lift the
RUNNING DECK
until
lock latch on side of treadmill
is fully engaged.
Remove
CONSOLE
from box
and place out of the way.
Lower the treadmill
RUNNING
DECK
from the folded position
by stepping on
LOCK LATCH
on
lower right side.
PRE-ASSEMBLY
WARNING
ASSEMBLY
STEP 1
A
B
C
D
E
F
G
H
#0-5 "
NN
2UZ
HARDWARE BAG 1 CONTENTS :
-&'5$0/40-&."45
-&'54*%&-*/,"(&"3.
#0-5"
* NOTE:
If the straps have been removed before completing step 1-D and the linkage arms can not be aligned,
refer to the TROUBLESHOOTING section (page 28) in order to restore the treadmill to its proper position.
