Connect the refueling station’s output valve to the car’s input valve turning clockwise while gently pressing in. Make sure the switch
beneath the car's chassis is at the "off" position.
Using the solar panel, make sure it is placed in direct sunlight. It will take about 10 minutes in strong sunlight for the car's tank to fill
up with hydrogen using the standard solar panel included. Keep the refueling station powered until the balloon inside the hydrogen
storage cylinder is full. Once the operation is complete and the balloon is full, make sure you turn the refueling station to the "off"
position.
Alternative: It will take at least 1 minute for the balloon to fill with hydrogen using the "DC"
power switch if the batteries are new.
TIP: After 20 minutes of continuous use, turn the Hydrogen Station off, and let it rest for at
least 10 minutes before starting it again.
Warning: Continuous operation of the
Hydrogen Station could damage it
permanently.
DC
off
Switch the refueling station to the "☼" sign. The small blue
lights will now be flashing and you are now producing
hydrogen fuel using unlimited power from the sun! You can
see you are producing hydrogen when small oxygen bubbles
form on the right side of the water tank. Turn the switch off
and the hydrogen production will stop.
If it is getting dark, or if the
sun is not very powerful, or
if you want to accelerate
refueling time, you can at
any time switch the
refueling station to "DC". In
this case hydrogen would
be produced using the
power of two AA alkaline
batteries (not included)
placed earlier inside the
refueling station.
To purge the complete fuel cell power system,
remove all the air out of the balloon by pulling
on the syringe. Stop pulling on the syringe
once all the air is removed from the balloon.
Disconnect the syringe connector valve from
the additional input valve attached to the
refueling station by turning it counterclock-
wise, allowing the connector to pop out. Your
storage tank is now purged and ready to
receive hydrogen from the refueling station.
Refueling and operation
Push all the air out of the syringe. Insert the gas
purging syringe into the car’s input valve turning the
syringe’s connector valve clockwise while gently
pressing in.
Summary of Contents for H-racer 2.0
Page 6: ......
