Revision -
14 of 22
8.
Remove the center under seat cover. There are no fasteners holding it in place. It
just lifts off.
9.
Remove the access panel located on the bottom of the firewall between the driver
and passenger foot wells. There are two 5 mm allen head bolts you must unscrew.
See Figure 10.
Figure 10: Remove the firewall access panel.
10.
Route the chassis wiring harness along the down tube on the driver’s side center
chassis tube (“B pillar”). The ends with the battery terminals and relay block
extend through the plastic trim, into the area under the driver’s side seat. Note:
The plastic rivet on the trim must be temporarily removed so the relay connector
can fit through the opening. See Figure 11.
