17
16
LUBRICATION
The motor is equipped with bearings which contain sufficient lubrication for its lifetime.
The addition of lubrication could cause damage. Do not add lubrication to motor.
HEXAGUARD
™
ACTIVATED
CARBON FILTER
INLET FILTER
The inlet filter is located on the inside,
bottom of bag housing and protects
the motor from damage.
1
The HexaGuard
™
Filters are
located on the inside of the filter
door. Pull to remove.
1
If the filter becomes dirty, pull
off the grill and lift out the filter.
Hand rinse in cold water under
low pressure. Let filter dry for 24
hours. Reposition dry filter and
snap grill into place.
IMPORTANT
ALLOW FILTER TO DRY COMPLETELY BEFORE REPLACING. DRY FILTER ON EDGE SO AIR CIRCULATES
ON BOTH SIDES OF FILTER. THIS MAY TAKE UP TO 24 HOURS.
REPLACEMENT
FILTER
Replace
HexaGuard
™
Filter
yearly for optimum
performance.
Part No. 440009176
REPLACEMENT
FILTER
Inspect
Inlet Filter
every
2 weeks to keep vacuum
running at peak performance.
Part No. 440009175
WARNING
TO REDUCE THE RISK OF PERSONAL INJURY – REMOVE BATTERY BEFORE CLEANING OR SERVICING.
DO NOT OPERATE VACUUM WITHOUT BOTH INLET FILTER AND FINAL FILTERS IN PLACE.
Filters
HEPA MEDIA FINAL FILTER
The final filters assist in the filtration process to return cleaner air to the room. There are 2 HEPA
Filters, one on each side of the backpack.
1
Remove filter door
by pulling rear tab
forward and rotating
out.
2
Pull filter out by the
frame. Hand rinse in
cold water under low
pressure. Rinse only
surface facing inside
of machine. Allow to
dry and reposition into
filter housing.
3
To replace filter door,
align the two forward
facing tabs and rotate
into place. Press rear
tab until door snaps
into place.
IMPORTANT
ALLOW FILTER TO DRY COMPLETELY BEFORE REPLACING. DRY FILTER ON EDGE SO AIR CIRCULATES
ON BOTH SIDES OF FILTER. THIS MAY TAKE UP TO 24 HOURS.
REPLACEMENT FILTER
Inspect
HEPA Media Final Filter
every month, rinsing when necessary. Check for
wear of media and replace if pleats are damaged. Change filter regularly to maintain
maximum performance.
HEPA Media Final Filter 2 Pack Part No. AH40006
WARNING
TO REDUCE THE RISK OF PERSONAL INJURY – REMOVE BATTERY BEFORE CLEANING OR SERVICING.
DO NOT OPERATE VACUUM WITHOUT BOTH INLET FILTER AND FINAL FILTERS IN PLACE.
