Hoover HDPH 2D1049B-80, User Manual

Page: 37 / 44

Troubleshooting
Problem Possible cause Possible solution
Acoustic alarm,
●
display shows
ALARMCODE
The appliance does
●
not fill with water.
Water tap is closed.
Open the water tap.
Water inlet hose has a kink or
a bend. Make sure that the position of
the hose is correct.
In case of aqua-stop system:
water protection is triggered;
the marker (C) is red.
The hose must be replaced.
Filter in the water inlet hose
is clogged.
Clean the filter at the inlet
hose connections at tap and
the rear of the appliance.
W
●
ater inlet is clogged. Check water flow from tap.
Water pressure is too low.
Contact your local water
authority.
Acoustic alarm,
display shows
ALARMCODE
Leak: The drain
pump
runs permanently! Anti- flood device is on:
There are water leakages in
the appliance.
The water inlet valve is
open and blocked.
The drainage is blocked.
1.Close the water tap.
2.Disconnect appliance from
power supply.
3.Contact Service.
Error codes on the display
All other Alarmcodes:
1. Note Alarmcode
2. Contact Service ; refer to CUS
●
TOMER SERVICE
E30
E10
35
Note: Whenever Error is
solved switch off the
appliance and restart the
programm.