Hoover HDPH 2D1049B-80, User Manual

Page: 15 / 44

13
Final checklist
To be completed by the installer
●
Check all parts are installed.
Ensure that all panels and parts thereof are secure and final electrical tests have
●
been conducted in accordance with local electrical regulations.
Check that the dishwasher is level. If necessary, adjust the levelling feet slightly.
To ensure optimum performance, the dishwasher should not be inclined more than
1
o
. Check with a spirit level.
Ensure inlet hose to water supply has supplied rubber washer fitted, and that it’s
tightened a further half turn after seal contact.
Ensure any knockouts or plugs in drain connection have been drilled out and drain
connection has been made.
The drain hose joiner must not support the weight of excess hose material. Keep
drain hose as f
●
ully extended as possible to prevent sagging. Any excess length of
drain hose should be kept on the dishwasher side of the highloop.
●
If connecting the drain hose to the sink trap, ensure the highloop is a minimum
150mm higher than the drain hose joiner.
Ensure any packaging or tape securing the racks is removed from the dishwasher.
●
Check that the door opens and closes freely without resistance to adjacent cabinetry.
Check that the electrical outlet is accessible and located in an adjacent cupboard.
Check the operation of the dishwasher:
If a fault code appears, see the ‘Fault codes’ section of the User guide for advice.
Installation instructions