Security Solutions Partner
5
data is being transferred
Audio:
The connector is used to plug in external speaker
MIC
: The jack is used to plug in an external microphone
I/O Interface:
Pin
1 Output A, Pin 2 Output B, Pin 3 Alarm input, Pin 4 Input (GND)
Reset Button:
Press and hold the RESET button for 15s, then the IPCAM will be reset back to the default
factory settings.
(Please keep the power on when doing the RESET)
1.3.3 Bottom View
Figure 1.3
There are some stickers at the bottom of IPCAM, such as MAC address sticker, QC sticker etc.
If your camera does not have these stickers, it may be a fake one, fake IPCAMs could not use the original
firmware.
1.4 PC System Requirements
System configuration requirements :
( Example for viewing four IPCAM)
CPU:
2.06GHZ or above
Memory
: 256M or above
Network Card:
10M or above
Display Card
: 64M or above memory
Recommendable Operating system:
Windows 2000/ XP/ Vista/ 7
1.5 Hardware Instruction
Follow the steps below to set up your camera hardware. Make sure to follow each step carefully to ensure that
the camera operates properly.
1. Install the Wi-Fi antenna
2. Plug the power adaptor into the camera
