Hoobico FLW4090, Building And Operating Instructions

Page: 8 / 16

8
ENGLISH
ELEVATOR ASSEMBLING
Please glue the flaps to the elevator in the same way, which
you did with the rudder flap. Sand the fiberglass levers a little
and glue them into the prepared slots on both sides.
As linkage use the 115 mm threaded bolt with swivel ball links
on both sides.
Use the M2x10 screws to mount the ball links to the fiberglass
levers and the servo levers. For installing the elevator servos,
you need a servo cable extension with about 500 mm of
length. Take care, that both cables have the same length and
thickness. Different cables cause different speed of servos.
When mounting the elevator servos it may be necessary its
intended servo slot to enlarge somewhat. For this use a file or
a small separating disk.
It is very important, that both flaps are in same position all over
their movement range. If necessary, adjust the movement of
the elevator flaps with your radio software.
Take a bowden cable to implement the steering wires into the
fuselage and pull them crosswise to the servo control lever.
Fix the rudder with a tape in neutral position, stretch the steel
rope and crimp in the same way, like on tail linkage. You can
adjust the tension by twisting the eye bolts.