31
MAINTENANCE
EN
CLEANING
• Do not use vinyl-based preservation agents and chemical cleaning products, other than dishwashing liquid type soap prod-
ucts, as they may damage and/or dry out the tubes material.
• Avoid waxes or alcohol-based cleaning products which may damage or dry out the tubes material.
• Spray down the boat and its accessories with water after each use. To prevent mould and mildew from forming, allow all ac-
cessories to dry before storing them in their bag.
• Although made up of stainless steel, some spots of rust may appear on the hole-pin axles. To remove them, use a scouring
sponge and soapy water.
DISASSEMBLY
NOTE:
Carefully clean the boat before rolling it up. Remove all sand, small rocks and other objects which may have remained
adhered to the boat.
1. Deflate the boat: press in fully the yellow button on each valve and turn it one fourth turn to lock it open.
2. Remove the bench.
3. Type "A" boats only: remove the stringers. Remove the deck elements, finishing at the ends.
4. Place the oars, stringers, deck elements (type "A" boats) and other accessories in their bag.
5. With the boat flat, fold the tubes [1] toward the inside of the boat [2]. Once folded, the tubes must come into contact without
overlapping.
6. Fold the end of the tubes onto the transom [3].
7. Use the foot pump in suction mode to remove the remaining amount of air from the tubes. Close the valves.
8. Roll the boat up starting from the rear [4] and place it in its transport bag [5] with the air pump.
