3 - 13
Deactivation Character
This sets the character used to terminate scanning when using Character Deactivation Mode. On the
, page A-3, find the hex value that represents the character you want to use to terminate scanning.
Scan the following bar code, then use the
to read the alphanumeric combination that represents that
ASCII character. Scan
to finish
.
Aimer Delay
The aimer delay allows a delay time for the operator to aim the scanner before the picture is taken. Use these codes to set the
time between when the trigger is pulled and when the picture is taken. During the delay time, the aiming light will appear, but
the LEDs won’t turn on until the delay time is over.
Default = Off.
User-Specified Aimer Delay
If you want to set your own length for the duration of the delay, scan the bar code below, then set the time-out by scanning
digits (0 - 4,000 ms) from the
inside the back cover of this manual, then scan
Save
.
Aimer Mode
This feature allows you to turn the aimer on and off. When the
Interlaced
bar code is scanned, the aimer is interlaced with the
illumination LEDs.
Default = Interlaced.
Deactivation Character
200 milliseconds
400 milliseconds
* Off
(no delay)
Delay Duration
Off
* Interlaced
Summary of Contents for Youjie HH660
