3 - 15
Character Deactivation Mode
If you have sent a character from the host to trigger the scanner to begin scan-
ning, you can also send a deactivation character to stop scanning. Scan the
On
bar code below to use character deactivation, then use Deactivation Character
(following) to select the character you will send from the host to terminate scan-
ning.
Default = Off.
Deactivation Character
This sets the character used to terminate scanning when using Character
Deactivation Mode. On the
ASCII Conversion Chart (Code Page 1252)
page A-3, find the hex value that represents the character you want to use
to terminate scanning. Scan the bar code below, then use the
to read the alphanumeric combination that represents
to finish
.
* Off
On
Deactivation Character
Summary of Contents for VOYAGER 1250G
