Honeywell Tuxedo, User Manual

Page: 36 / 48

Automation (cont'd)
36
Exclude/Delete Z-Wave Devices
Exclude a Light, Switch or Outlet Module
To exclude a light, switch or outlet module from the Z-Wave network, do the following:
ICON ACTION NOTES
1. At the Tuxedo Touch Keypad:
a) Press the
Automation
icon from the “Home”
screen and then press
Z-Wave Setup
icon to
display the “Z-Wave Device Management” screen.
2. At the device module:
a) Press the
Function Key
to exclude the device
from the keypad.
Z-Wave Exclude/Delete -clears the node from the keypad and
resets device to the default setting.
Notes:
•
If the device is not excluded, refer to the “Z-Wave
Troubleshooting” section.
•
To remove a defective device, refer to the Z-Wave
Troubleshooting section.
Exclude/Delete a Door Lock
To exclude a door lock module from the Z-Wave network, do the following:
ICON ACTION NOTES
1. From the “Home” screen, press the
Automation
icon and the
Z-Wave Setup
icon. The “Z-Wave
Device Management” screen is displayed.
Z-Wave Exclude/Delete -clears the node from the keypad and resets device
to the default setting.
Notes:
•
If the device is not excluded, refer to “Z-Wave Troubleshooting”.
•
When excluding the door lock, the user code associated with the
door lock will remain in the system. If needed refer to the panel
Installation Instructions on how to remove this user code.
•
To remove a defective device, refer to the section on
Troubleshooting.
2. Highlight the device to exclude and press the
Z-
Wave Exclude/Delete
icon.
3. On the device press the
Function Key
to
exclude the device from the keypad.
Exclude/Delete a Honeywell Thermostat
IMPORTANT: Honeywell is not responsible for property damages due to improper setting of the thermostat modes.
To exclude a Honeywell Thermostat from the Z-Wave network, do the following:
ICON ACTION NOTES
1. At the Tuxedo Touch Keypad:
a) Press the
Automation
icon from the “Home”
screen, and then press the
Z-Wave Setup
icon.
2. At the thermostat:
a) Follow the instructions in the thermostat
Installation Guide under “ Installer setup ” to
“Remove a Z-Wave Network Connection”.
b) Press
Done
; the thermostat is excluded.
Z-Wave Exclude/Delete -clears the node from the keypad and resets
device to the default setting.
Note: To remove a defective device, refer to the “Z-Wave
Troubleshooting” section.