ACTIVATION
Page 23
ACTIVATION
Identification via the Service Pin
To identify the node, you can activate the service pin by means of a
reed sensor located inside the unit (see Figure 12). This procedure
consists of the following steps:
1.
Place a magnet in front of the service reed sensor (see Figure 14).
2.
The TemaServer then sends a
wink
command in response to the
service pin, which makes yellow LED flash for 2 seconds. This allows
you to verify that communication to and from the TemaServer is
working.
3.
Check that the service LED remains off after you have completed
this operation.
SERVICE LED
SERVICE
REED SENSOR
M
A
GN
E
T
Honeywell
RTUA01P
Figure 12. Service Elements
