OPERATOR MANUAL // SECTION 2: INSTALLATION
HONEYWELL
10
This current load must also be considered while calculating the Panel's 24-
hour backup power requirements.
2.2 Enclosure
Installation (Optional)
2.2.1. Swivel
Mount
(SM2):
a.
Select fasteners for the swivel mounting such that they will secure it
to the type of material at the enclosure location.
b.
Mount the swivel-mount to the wall assuring correct orientation.
c.
Install the mounting bracket onto the Model SS2 Detector
enclosure using the #¼-20 or #6 mm screws and nuts provided.
If oriented correctly, the outside contours of the mounting ears
on the Detector enclosure and the ends of the bracket will
match. The large diameter of the threaded insert should face
the enclosure.
d.
Screw the enclosure/bracket assembly onto the ball or swivel
stud. Turn the Detector until the stud bottoms against the
enclosure.
Do not tighten.
While holding the enclosure, tighten
the jam nut against the bracket.
e.
While holding the enclosure, loosen the socket head screw on
the SM2 swivel-mount. Position the enclosure in such a way
that the conduit openings are located horizontally at the bottom.
Point the enclosure in the desired direction and tighten the
appropriate hardware.
2.2.2 Install
Conduit
(If not already installed).
Figure 2. Model SS2 Detector with SM2 Swivel Mount
