Honeywell Rapid Eye LT, Installation Manual

Page: 52 / 78

52
Site Hardware
Caution Do not “T-tap” the cable; this can introduce unwanted distortion into the
video signal. To obtain a video feed, use an output port on the Multi-Media
LT DVR.
Using LocalView for Public Display
You have the option of using VGA monitor(s) as a public display monitor. Set LocalView to
display the camera(s) that you need. More than one camera can be displayed
simultaneously. For a better public display of video, and if displaying one video feed at a
time is satisfactory, Honeywell recommends using a dedicated NTSC (or PAL) monitor,
rather than the VGA output used for LocalView.
Connecting a PTZ Dome
Connection to the DVR
Connect the Data In port of a PTZ dome (an RS485 connector) to one of the ports on a
Multi-Media LT DVR. Serial ports 3 and 4 do not need a 232/485 converter.
Figure 5-3 Serial Ports 1 to 4
ACUIX Camera
An ACUIX™ PTZ camera dome with Intellibus™ can be connected to a Rapid Eye
Multi-Media LT DVR and configured using Rapid Eye View software.
1. Set ACUIX cameras to their Intellibus mode (Intellibus-PTZ).
SERIAL PORT 2
SERIAL PORT 1 VGA
TELCO
USB USB
LAN
IN
OUT
NOT
USED
1 2 3 4
5
6 7 8
SPOT
MONITOR
VIDEO
INPUTS
COMMON
SYS FAIL
SYS GOOD
F AULT
RELAY
28V, 3A
MAX
1 G G G G 2 3 4
CONTROL
OUTPUTS
SERIAL
PORT 3
SERIAL
PORT 4
1 G G G G 2 3 4 5 G G G G 6 7 8
ALARM INPUTS
ON/OFF
POWER
115-230V~
50/60 Hz
5-3A
Serial Ports 3
and 4: RS485
ports (8-pin)
See
Connectors
for Serial
Communications
on page
50
for
pinout information
for serial
Ports 1
and 2
and for serial
Ports 3 and 4
.
Serial Ports 1 and 2:
RS232 ports (9-pin)