There is an optional pre-filter that can be purchased and used with this air purifier that will help reduce
common household odors and VOCs. This
K
Pre-filter (HRF-K2) can be used in lieu of the permanent
washable pre-filter that is supplied with the air purifier. The optional
K
Pre-filter should be replaced
every 3 months for optimum odor and VOC reduction performance.
You may purchase
Honeywell
replacement Odor & VOC Reducing Pre-filter
K
at the store where you
purchased your air purifier or they can be ordered directly from www.replacementfilters.com
If you have any questions about your ifD
®
filters or the Washable Pre-filter (T.3024), visit our website
at
www.kaz.com
or call Consumer Relations at 1-800-477-0487.
How often is cleaning required?
About every 3 months depending on the air quality of the room. We recommend washing the ifD
®
filters when needed but not more than once a month.
How long should I run my Air Purifier?
In general, it is recommended that you run your air purifier when you are at home to clean the air. The
unit may be run 24/7 if preferred. This unit will be more effective when doors and windows are closed.
How do I use the additional pre-filter that is packed in the plastic bag?
Your air purifier came with a installed washable pre-filter that helps capture the larger airborne particles
before they reach the ifD
®
filters. If you would like the additional benefit of Odor & VOC Reduction, you
may replace the washable pre-filter with the Odor & VOC Reducing
K
Pre-filter that was packed in a
plastic bag with the purifier. You must first remove the washable pre-filter that came in your air purifier
and replace it with the
K
pre-filter. This pre-filter is not washable and should be replaced every 3
months for optimum performance.
We recommend that you clean the air purifier at least every 3 months and before extended storage. Use
only a dry cloth to wipe the external surfaces of the air purifier.
DO NOT USE WATER, WAX POLISH, OR
ANY CHEMICAL SOLUTION.
FREQUENTLY ASKED QUESTIONS
CLEANING AND STORAGE
CLEANING THE IFD
®
FILTERS
To clean the ifD
®
filters:
• After removing the ifD
®
filters from the air purifier, follow the steps below to
wash the ifD
®
filters.
Turn the power off and unplug the air purifier.
• Rinse the filter with clean tap water (Fig. 6)
• If the filter still appears dirty, proceed to “Washing,”
otherwise proceed to “Drying.”
Washing:
• Remove the ifD
®
filters from the unit.
• Fill a sink with lukewarm water and add a few drops of mild dish soap.
• Gently swish the filters in the soap solution to clean.
• Soak the filters for 2-3 minutes. Do not leave for an extended period of time.
• Rinse the filters with clean tap water (Fig. 6).
Drying:
• Shake the filters to remove any excess water.
• Place the filters with the honeycomb side down on a plush towel.
•
Note that the filters may still be discolored even after washing.
This is acceptable and will not affect performance.
• Allow the ifD
®
filters to dry for a few hours or overnight.
• When the ifD
®
filters are
completely dry
, place back into the air purifier.
CAUTION:
•
Never place wet ifD
®
filters in your air purifier.
• The ifD
®
filters are NOT dishwasher safe. Do not place the ifD
®
filters in a dishwasher or subject them
to other extreme hot water conditions.
• Do not use any solvents, strong cleaning agents or flammable liquids to clean the ifD
®
filters.
Fig. 6
REMOVING THE FILTERS
The ifD
®
filters are supplied within the air purifier.
•
Turn-off power and unplug the air purifier.
While pressing on the release tab at
the top of the rear grille, pull the grille towards you and remove it (See Fig. 5).
Gently push along the edge of the filter frame and pull forward. Repeat for the
second filter.
• After cleaning, place filters back into the air purifier housing and snap filter grille
back into place.
Fig. 5
4
5
The pre-filter helps capture large airborne particles that
enter the rear grille. This pre-filter can be periodically
removed and shaken to clean it. Alternatively, it can be
rinsed by hand under warm water (Fig. 7). Let the
pre-filter air dry completely before inserting back into
the grille (Fig. 8). If you need to replace this item, please
call 1-800-477-0457 or visit www.kaz.com.
OPTIONAL: Changing the Odor Absorbing Pre-Filter
If you have chosen to use the odor absorbing
K
pre-filter it will lose its
effectiveness for odor adsorption over time and will need to be replaced.
To purchase additional
K
Pre-filters, see Accessories section below.
To install the
K
pre-filter, simply remove it from the bag and place securely into
the rear grille in lieu of standard pre-filter as shown in Figure 8.
If using the odo r absorbing filter, it is recommended that you store the original
washable pre-filter in the event that you decide to use it in the future.
NOTE: The odor absorbing pre-filter is not washable.
Fig. 7
Fig.8
Pre-filter
Rear Grille
MAINTAINING YOUR WASHABLE PRE-FILTER
ACCESSORIES AND REPLACEMENT FILTERS