50078099-001 Rev.A
GB - 1
PEHA_M_1602-2_USB_SPV (Rev01-130604)
Elektro GmbH & Co. KG
1602/2 USB SPV o.A.
USB Charger
Installation & operating instructions
GB
DESCrIPTIOn
APPLICATIOn
The USB Charger is suitable for charging portable electronic
devices connected via a USB 2.0 type A plug. Up to two de-
vices such as mobile phones and MP3 players can be char-
ged simultaneously.
note:
– Read through the operating instructions carefully before
putting the device into service.
– Please observe the charging instructions of the devices!
PrODUCT fEATUrE
Twin Charging Sockets:
The USB Charger comes with two
charging sockets capable of delivering a total maximum
charging current of 2A. This can be delivered to either socket
or divided between the two as required and controlled by
the devices being charged.
Zero Standby:
The Charger will draw no current from the
mains until a connector is inserted into either connection port.
Safety Isolation:
The output of this product is fully isolated
at SELV level to provide maximum protection for your safety.
Output Overload Protection:
The Charger is protected against
over-current and short circuit conditions on the output.
SAfETy
CAUTIOn! Danger of electrical shock!
The housing contains current-carrying components.
Contact can lead to personal injury! All work on the
mains network and the device may only be done by
an authorised electrician.
• Disconnect power supply from the device.
• Secure the device against being powered on again.
• Check that the device is powered off.
• Close the housing securely before applying power.
This device is only intended to be used for its stated appli-
cation. Unauthorised conversions, modifications or changes
are not permissible!
This device may not be used in conjunction with other de-
vices whose operation could present a hazard to persons,
animals or property.
The following must be observed:
• Prevailing statutes, standards and regulations.
• State-of-the-art technology at the time of installation.
• The device’s operating instructions.
• Operating instructions can only cite general stipulations.
These are to be viewed in the context of a specific system.
TECHnICAL InfOrMATIOn
Operating voltage
220 to 240V~ / 50-60 Hz
Total output power
10W
Rated input current
60mA
Standby
0W
Charging sockets
USB 2.0 type A
Output voltage
5 V DC
Output current
2.0 A max
Operating
temperature
0°C to 40°C
Storage
temperature
– 20°C to 70°C
Protection level
IP20
EC Directives
Low Voltage Directive
EMC Directive
Standards
IEC 61558-2-16
IEC 61000-6-1 and IEC 61000-6-3
InSTALLATIOn
IMPOrTAnT
InSTALLATIOn InfOrMATIOn !
Installation and commissioning may only be done by an
authorised electrician. Mains power (230V~/50Hz) to elec-
trical equipment must be switched off during installation.
Applicable laws and standards of the country in which the
device is operated must be observed!
This device is intended for installation in a 60 mm wall box.
They are to be equipped with the 1-5 multipurpose frame
from the PEHA switch range.
Caution:
Only operate USB Charger in protected locations,
and avoid influence of humidity, dust, sun and heat. This
product
MUST nOT
be installed in bathrooms, washrooms
or any location subject to splashes of water, condensation
or excessively damp conditions.
Scale 1:1
220-240V~
50/60 Hz
1602/2 USB SPV
USB Charger
Output: 5V DC / 2A
ta = 40°C
L
N
Scale 2:1
220-240V~
50/60 Hz
1602/2 USB SPV
USB Charger
Output: 5V DC / 2A
ta = 40°C
L
N
L
L
N
n
brown blue
220 - 240V~
50-60 Hz
• Switch off mains voltage.
• Protect power supply line with a MCB (max. 16 A)!
• Ensure that the device is mounted on an
even surface in the vertical plane.
• Mount the wall box in a suitable position.
• Install connection cables
L
(brown) and
n
(blue).
• Secure device in the wall box and mount cover plate.
• Switch on mains voltage.
GEnErAL InfOrMATIOn
DISPOSAL Of THE DEVICE
Do not dispose of old devices in the household
waste! The device must be disposed of in compli-
ance with the laws and standards of the country in
which it is operated!
The device contains electrical components that must be dis-
posed of as electronics waste. The enclosure is made from
recyclable plastic.
wArrAnTy COnDITIOnS
These operating instructions are an integral part of both the
device and our terms of warranty. They must be handed over
to the user. The technical design of the appliance is subject
to change without prior notification.
PEHA
products are
manufactured and quality-checked with the latest techno-
logy according to applicable national and international re-
gulations. Nevertheless, if a product should exhibit a defect,
PEHA
warrants to make remedy as follows (regardless of any
claims against the dealer to which the end-user may be en-
titled as a result of the sales transaction):
In the event of a justified and properly-established claim,
PEHA
shall exercise its prerogative to either repair or re-
place the defective device. Further claims or liability for
consequential damage are explicitly excluded. A justifiable
deficiency is one in which the device exhibits a structural,
manufacturing, or material defect that makes it unusable or
substantially impairs its utility at the time it is turned over to
the end-user. The warranty does not apply to natural wear,
unintended usage, incorrect connection, device tampering
or the effects of external influences. The warranty period is
for 24 months from the date of purchase by the end-user
from a dealer and ends not later than 36 months after the
device’s date of manufacture. German law shall be applica-
ble for the settlement of warranty claims.
COnTACT
Telephone: .........................+49 (0)2351 185-0
Fax: ....................................+49 (0)2351 27666
Internet: ............................www.peha.de
E-mail:[email protected]
PEHA Elektro GmbH & Co. KG
Postfach 1727 • D-58467 Lüdenscheid • Internet: www.peha.de
