- 20 -
Program and Operation
The Pattern function stores user’s control of the selected dome camera for up to 240 seconds.
4 patterns can be stored in 240 seconds of total recording space. Stored pattern is played back
by pressing
No.+ Pattern
buttons subsequently
Pattern Setup
NO TILTIE SEC
O1 : PATTERN1 000
O2 : PATTERN2 041
O3 : PATTERN3 010
O4 : PATTERN4 020
TOTAL:
071
Save And Exit
1.4 PATTERN (
MENU
=> Function =>
Pattern
; Short cut : PATTERN)
Follow the steps below to program the Pattern:
1.
Select the camera number by pressing
0 ~9
and
CAM
.
2.
Simply press the
Pattern
key. (or
MENU
=> Function =>Pattern)
3.
Select the empty Pattern number to be programmed by pushing the Joystick Up or Down. If
SEC column is not 000, then the selected No. of pattern is already recorded.
4.
Twist the
Joystick
to enter recording mode and control the camera direction and zoom with
the
Joystick
. Your controls will be automatically recorded. You can repeat this procedure
until you are satisfied with the pattern recorded. (Or twist zoom handle or hit zoom button
to start PTZ control for view selection and hit the Focus button to stop.)
5.
Scroll down to the Save and Exit option and push the
Joystick
to the right to save and exit.
6.
You can title the selected Pattern by pushing the
Joystick
to the left or right. Rotate the
handle clockwise or counterclockwise to scroll through the alphanumeric characters, push
the handle to right or left to select next or previous space.
7.
Pressing
ESC
will not save currently recorded data and exits to the previous menu mode.
Press the
HOME
or
OFF
button at any programmed position to delete the programmed
pattern.
NOTE: If total recording time reaches 240 seconds, it will automatically stop.
ENG
