27
Page 27
MI Modem
Mercury Modem Configuration Software and 40-2200 Configuration
Cable are used to program various modem functions, such as: Number
of Rings to Answer, Inactivity Time-out, Dial-in Phone Number,
Number of Alarm Retries and Modem ID Number, etc.
To install the DOS Version of the Modem Configuration Program,
place the diskette in the computers disk drive. At the DOS prompt
type the following:
C:>A:
(Press Enter)
A:>Install
(Press Enter)
The program creates a subdirectory called "MIMODEM" in the
Mercury directory. Then the following files are copied from the
diskette in the A: drive:
CFGMODEM.EXE
CFGMODEM.PIF
M1.BAT
M2.BAT
M3.BAT
M4.BAT
Before running the program you must determine which serial port the
configuration cable is attached to, for example: COM1, COM2 ...etc.
Once that is determined, at the C:>MERCURY\MIMODEM> prompt
type the following:
M1
(Press Enter, if connected to COM1)
M2
(Press Enter, if connected to COM2)
M3
(Press Enter, if connected to COM3)
M4
(Press Enter, if connected to COM4)
or you can type the command as follows:
CFGMODEM /C1
(Press Enter for COM1)
CFGMODEM /C2
(Press Enter for COM2)
CFGMODEM /C3
(Press Enter for COM3)
CFGMODEM /C4
(Press Enter for COM4)
Modem Configuration Program (DOS)
