Deleting Codes
To delete a code follow the steps to adding a code but instead of pressing add new you
will highlight the code you would like to delete and then select
DELETE
.
Testing
Your
Alarm
System
To test your alarm system first you must call Emergency 24 at 1-800-424-3624 the
operator will answer and you will tell them your six (6) digit account number and then your four
(4) digit code you use to disarm your alarm system. Once you tell them this data tell them you
would like to put the system on test for 2 hours. Once your system is on test turn your system on
for away and open and close the delay door and wait for the delay timer to run out and your
system to arm. Once the system is armed open and close of the doors/windows, walk in front of
motion sensors, and use something firm and hit the GLASSBREAKS not the glass but the
device. This will put your system into an alarm. Once you have activated every device go to the
keypad and disarm the system ONCE and only ONCE for now. After you have disarmed the
system on the keypad press the ZONES button to view which devices went into alarm.
(Reference your zone list for this) If any devices did not show up on the keypad repeat the
previous steps but only activate the devices that did not show up the first time. (If they do not
show again call R.J. Beck for service) once you get all of your devices activated and referenced
disarm your system again and then call Emergency 24 back and give them the information again
and then ask if they have received any signals recently. If they receive all of the signals and all of
your devices showed up on the keypad tell them to take the system off of test. If they do not
receive any signals call R.J. Beck for service.
