Limitless™
WDRR Receiver
Issue 1,
50063987
Honeywell Sensing and Control 25
Figure 9. Limitless™ switch to WDRR Antennas with RF Signal Line of Sight (LOS) Free From Obstacles
Figure 10. Limitless™ switch to WDRR Antennas with RF Signal Line of Sight (LOS) Affected by
Obstacles
8.3.2
Outdoor Installation Warnings
WARNING
LIVES MAY BE AT RISK!
Carefully observe these instructions and any special instructions included with the equipment being installed.
WARNING
CONTACTING POWER LINES CAN BE LETHAL
Look over the site before beginning any installation and anticipate possible hazards, especially these:
•
Make sure no power lines are near where possible contact can be made. Antennas, masts, towers, guy
wires, or cables may lean or fall and contact these lines. People may be injured or killed if they are
touching or holding any part of equipment when it contacts electric lines. Make sure there is NO possibility
that equipment or personnel can come in contact directly or indirectly with power lines.
•
Assume all overhead lines are power lines.
•
The horizontal distance from a tower, mast, or antenna to the nearest power line should be at least twice
the total length of the mast/antenna combination. This will ensure that the mast will not contact power if it
falls during either installation or later.
WARNING
TO AVOID FALLING, USE SAFE PROCEDURES WHEN WORKING AT HEIGHTS ABOVE GROUND
•
Select equipment locations that will allow safe, simple equipment installation
•
Don’t work alone. A friend or co-worker can save a life if an accident happens.
•
Use approved, non-conducting ladders and other safety equipment. Make sure all equipment is in good
repair.
•
If a tower or mast begins falling, don’t attempt to catch it. Stand back and let it fall.
•
If anything such as a wire or mast does come in contact with a power line, DON’T TOUCH IT OR
ATTEMPT TO MOVE IT. Instead, save a life by calling the power company.
•
Don’t attempt to erect antennas or towers on windy days.