4
5
1
1
2
3
$
1
2
3
4
NOTE:
Position humidifier to direct mist output away from walls, furniture and bedding.
1.
Power On:
With the Mist Control Wheel in the OFF position, plug the filled humidifier into a polarized
120V outlet.
CAUTION: To avoid electric shock, DO NOT plug humidifier into an outlet with wet hands.
2. Slide the Control Wheel up or down to reach desired humidity level. More lights mean more mist output.
To turn off humidifier, turn Control Wheel down until it clicks and all lights turn off.
3.
Humidity Level:
When a comfortable humidity level is reached, turn Control Wheel to a lower setting.
A comfortable humidity level is between 40-60%. Consider using a humidity monitor to display current
room humidity and temperature.
CONDENSATION:
If you notice condensation on the walls, windows or around the humidifier, the humidity
level is too high. Turn off humidifier until humidity level drops.
4. Tank Light:
Press the Tank Light button to control the light in the Water Tank. There are three settings:
Bright, Dim, or Off.
Using The Essential Oil Tray
This humidifier features an Essential Oil Tray that can be used with your favorite essential oil for added enjoyment.
This not a diffuser - the oil does not come in contact with water and is passively evaporated into the air. Essential
oil is sold separately.
1. Slide the tray open.
2. Add a few drops of essential oil to the Pad.
WARNING:
DO NOT
pour any liquids into the Mist Outlet.
DO NOT ADD LIQUID INHALANTS,
ESSENTIAL OILS OR ANY ADDITIVES TO THE WATER TANK. DOING SO CAN HAVE ADVERSE EFFECTS
ON THE HUMIDIFIER AND VOID THE WARRANTY.
3. To clean the Essential Oil Tray, gently wipe residue from the Tray.
Daily Maintenance
For best results, use fresh clean water every day.
4
USING YOUR HUMIDIFIER
1
2
3
SETTING UP YOUR HUMIDIFIER
Unpack the Humidifier
Keep this instruction manual for reference
Remove packaging materials.
1. Remove twist tie and extend power cord. Place on a firm, level, water resistant surface a minimum of 12”
(30cm) from any walls.
Hard Water and White Dust
High mineral content in your water, also known as hard water, may cause a white mineral residue to accumulate
on surfaces in the room near the humidifier. This mineral residue is commonly referred to as white dust. The
higher the mineral content (hardness) of your water, the greater the potential that an ultrasonic humidifier may
produce white dust.
White dust is not a result of a defect or flaw in the humidifier. It is a result of the amount of minerals suspended
in the water you are using.
FILLING / REFILLING
NOTE:
Tank should be carried using two hands; one hand on the Tank Handle and the other supporting the
bottom of the Tank.
Kaz USA, Inc. will not accept responsibility for property damage caused by water spillage.
This humidifier holds 1.25 gallons (4.5 liters) of water (tank and reservoir combined).
Filling
1. Remove Water Tank and turn upside down. Remove Tank Cap by turning counter clockwise (left). Fill Tank
with cool water.
DO NOT
fill with warm or hot water.
2. Replace Tank Cap by turning clockwise (to right) to screw back in place.
DO NOT
over-tighten.
3. Place Tank in humidifier Housing. Water will drain from the Tank into the Reservoir when the Plunger
is engaged.
4. When the Tank is empty, the humidifier will shut off and the refill light will turn on. Refill the tank following
the instructions above.
