To start the TDC emulator service
1. Choose Start > Run.
The Run dialog box appears.
2. Type services.msc.
The Services page appears.
3. Right-click TDC Emulator service and click Start.
3.5.4
Checking the LCNP4e/LCNp4e2 status
If this is an Experion “T” node or a TPS node with the LCNP4e/LCNp4e2 board installed, perform the
following steps to verify the LCNP4e/LCNp4e2 passed self test.
To check the LCNP4e/LCNp4e2 status
1. Choose Start > Programs > Honeywell TPS > LCNP Status.
2. Verify that the LCNP status indicates Passed Self Test and the circle is green.
3. Verify that the TPN Address appears in the LEDs field of the LCNP Status display, after the Board 0
is configured for the node’s TPN address. You must reset the LCNP after configuration.
TIP
For more information, refer to the
LCNP Status User's Guide.
- 33 -
Chapter 3 - Installation
