50461/GTEX MMC/1111
5
UTImeter Gtex MMC
3. General information
3.1 Shipment
note
The following parts should be included in the
shipment:
-
1 instrument fitted out with one battery in the
display;
-
1 set of 4 Allen keys: 1.5, 2, 2.5 and 3 mm;
-
1 Operation and Service Manual.
3.2 Initial
inspection
Check the contents of the shipment for
completeness and note whether any damage has
occurred during transport. Carry out the “Initial
test before installing the instrument” to verify the
good functioning. If the contents are incomplete,
or if there is a damage, do not use the device. A
claim should be filled with the carrier immediately,
and Enraf Tanksystem SA Sales or Service
organization should be notified in order to
facilitate the repair or replacement of the
instrument.
3.3 Documentation
discrepancies
The design of the instrument is subject to
continuous development and improvement.
Consequently, the instrument may incorporate
minor changes in detail from the information
contained in the manual.
3.4 Warranty
Three (3) years after installation but max. 42
months after delivery ex works except
batteries.
The Vendor undertakes to remedy any defect
resulting from faulty design materials or
workmanship. The Vendor's obligation is
limited to the repair or replacement of such
defective parts by his own plant or one of his
authorized service stations. The Purchaser
shall bear the cost and risk of transportation
of defective parts and repaired parts supplied
in replacement of such defective parts.
When returned to Enraf Tanksystem SA or any
of its agreed Service Stations equipment must
be contamination-free. If it is determined that
the Purchasers equipment is contaminated, it
will be returned to the Purchaser at the
Purchasers expense. Contaminated
equipment will not be repaired, replaced, or
covered under any warranty until such time
that the said equipment is decontaminated by
the Purchaser.
The Purchaser shall notify by fax, telex or in
writing of any defect immediately upon discovery,
specifying the nature of the defect and/or the
extend of the damage caused thereby.
Where no other conditions have been negotiated
between the Vendor and the Purchaser "General
Conditions 188" of United Nations shall apply.
This instrument has been certified as Intrinsically
Safe Instrumentation for only those classes or
categories of hazardous areas stated on the
instrument label, bearing the mark of the
applicable approval authority. No other usage is
authorized.
Unauthorized repair or component replacement
by the Purchaser will void this guarantee and may
impair the intrinsic safety of the instrument. In
particular it is not allowed to repair electronic
circuits.
In no event shall Enraf Tanksystem SA be liable
for indirect, incidental or consequential loss or
damage or failure of any kind connected with the
use if its products or failure of its products to
function or operate properly.
Enraf Tanksystem SA do not assume the
indemnification for any accident or damage
caused by the operation of its product and the
warranty is limited to the replacement of parts or
complete goods.
