Honeywell HD4MDIP, User Manual

Page: 29 / 78

HD4 EQUIP Series IP Dome Cameras User Guide
Document 800-05620 Rev C 29
04/10
Figure 2-10 Gimbal Adjustment
Adjusting the Lens Focus
Lenses are pre-focused at the factory. They might require a final adjustment after
installation in the unlikely event the optical effect of the dome bubble causes a slight
defocusing of the lens.
TECH TIP! To check the focus, hold the dome bubble over the lens while making any adjustments.
Restoring Factory Defaults
Your camera has a Factory Reset button located inside the camera (see Figure 2-10 ). Use
this button to restore your camera options and passwords to their default settings. Use a
pin or straightened paperclip to press and hold the Reset button for three seconds.
Legend
A = Tilt rotation
B = Horizontal rotation
C = Pan rotation
Angle view
Top view
B
C
A
Setscrew (loosen to
adjust horizontal
rotation)
Loosen locking screw
(inside conduit entry)
to remove the side
conduit plug.
Set focus
(top)
Set focal length
(bottom)
Local video out
Factory reset
button