40
FL-PS Series Instruction Manual —
P/N LS10227-001FL-E:B 3/29/2021
Application Examples
Controlling NACs, Aux Power, and Door Holders with NAC Sync
B.4 Controlling NACs, Aux Power, and Door Holders with NAC Sync
In this application, use of a single CDRM-300 mounted inside the cabinet can monitor the two power supply trouble relays and trigger
two independent inputs via relay circuits. FL-PS outputs #1 and #2 are being used for 24 VDC aux power triggered by the module’s relay
circuits. Any FL-PS output circuit can be configured to follow any input circuit.
The following notes apply to Figure B.4.
•
Any output circuit can be configured as NAC, door holder, or 24VDC power.
•
Refer to Section 3 for instructions on setting the DIP switches.
•
Do not loop wires under screw terminals. Break wires to maintain proper supervision.
•
An End-of-Line Resistor must be installed between terminals 1 and 4 for module wiring supervision (the ELR value is dependent
on the module/FACP employed).
•
An End-of-line Resistor on input circuits#1-2 (TB5-6) are optional for this particular application.
•
Ensure that the CDRM-300 is programmed appropriately at the FACP where the inputs are
not
mapped to the same zone as its
outputs.
•
For a list of compatible devices, refer to the
Fire•Lite Device Compatibility Document #
15384.
•
Refer to the
SLC Wiring Manual
for more information.
NO NC C
NO NC C
TB4
TB15
T
B
2
T
B
1
T
B
1
3
T
B
1
2
T
B
1
1
T
B
1
0
T
B
9
T
B
8
T1
T2
T3
T4
T5
T6
T1
2 N
C
T1
1 C
T1
0 N
O
T9 NC
T8 C
T7 NO
NAC or Remote
Sync Output
FACP
SLC
CDRM-300
Figure B.4 Controlling NACs, Aux Power, and Door Holders with One Input and NAC Sync
End-of-Line Resistors
supplied with Module
24VDC Aux Power
AC
Trouble
Trouble
