MS-5UD & MS-10UD Series Manual —
P/N 52626:C2 1/24/2012
79
Master Programming Level
Programming
Time-Date
The control panel time and date can be changed by pressing
3
while viewing the System Setup
Screen #1. The following screen will be displayed:
Time
To change the time, press
1
while viewing the Time-Date Screen. The following screen will be dis-
played:
A flashing cursor is located toward the top left of the display. Below the cursor is the current time.
To change the time, enter the two-digit hours followed by the two-digit minutes. The cursor will
move one position to the right each time a digit is entered. After the last minutes digit is entered,
the cursor will again move one position to the right. At this point enter
1
for AM or
2
for PM. The
display will then return to the Time-Date Screen which will show the new time entry. If an error is
made while entering a digit, press the
CLR
key to delete the entire entry and beginning again.
Date
To change the date, press
2
while viewing the Time-Date Screen. The following screen will be dis-
played:
A flashing cursor is located toward the top left of the display. Below the cursor is the current date.
To change the date, enter the two-digit month followed by the two-digit day and then the two-digit
year (07 for 2007, 08 for 2008, etc.). The cursor will move one position to the right each time a
SYSTEM SETUP
1=TIMERS
2=BANNER
3=TIME-DATE
System Setup Screen #1
TIME AND DATE
1=TIME 10:00 AM
2=DATE 07072007
3=CLOCK FORMAT 12HR
Time-Date Screen #1
TIME AND DATE
1=DAYLIGHT SAVINGS
Time-Date Screen #2
ENTER TIME AS 12HRS
10:00 AM
1=AM 2=PM
Time Screen
ENTER DATE
**-**-****
MONTH DAY YEAR
07-07-2007
Date Screen