Honeywell Evohome, Installation Manual, Page: 18 / 52

Power up and bind a Wireless Cylinder
Thermostat Transceiver (CS92)
On the CS92 Transceiver
1
Remove the CS92 Transceiver cover
2
Remove the battery tab and replace the cover
3
On the CS92 Transceiver press and hold the
button for 5 seconds. The green light should
come on and the red light should flash
4
Press the button again
5
You should receive a SUCCESS message on the
evohome Controller (if not go back and re-bind)
6
Choose the correct hot water valve type for the system
you’re installing and follow the on screen instructions
If you are NOT following
GUIDED CONFIGURATION
follow these steps on
your evohome Controller
display first:
1. Press and hold “Settings”
for 3 seconds
2. Press the green tick
3. Select GUIDED
CONFIGURATION
4. Press STORED HOT
WATER CONFIGURATION
5. Press the green tick
evohome
Controller
HOlD
5 SEC
PRESS
ONCE
3
1 12
PUll TAB
Wireless Cylinder Thermostat (CS92)
16 Step 3: Power up and bind devices