EchoView User’s Guide
17
7.
Programming The EchoView
Programming Mode is accessed by first providing the correct password.
Press and hold [MODE] and [N/-] until you see this screen:
Input the 4-digit password:
•
Increase the number from 0 through 9 by pressing [Y/+].
•
Decrease the number from 9 through 0 by pressing [N/-].
•
Step from digit to digit using [MODE].
Once all the four digits have been entered, press [MODE] again to see the following screen appear.
Press [Y/+] to enter the password.
If you make a mistake, you can cycle through the digits by pressing [MODE] and then using [Y/+]
and [N/-] to change the number in each position.
Note:
The default password is 0000.
If your password is incorrect, you see this screen:
After a few seconds, the EchoView exits to its main screen.
When you have successfully entered Programming Mode, you see this screen:
Note:
If you do not make a selection in 60 seconds, the EchoView automatically exits to the main
screen.
Press [Y/+] or [N/-] to scroll to “Settings,” “Wireless,” or “Exit.” Then press [MODE] to select your
choice.