Honeywell DR Graphic Installation Instruction Download Page 9

Page: 9 / 10

43-TV-33-214 iss.2 GLO May 2015 UK

Sr. No.

Cable Description

Source - Description

Relay extension cable – for status of power
relay

Power supply Board to Backplane board (J10)

Touch Screen Extension Cable – for
extending the touch screen connections
from the touch screen to the CPU board

Touch screen in Bezel to CPU board in case (J5 – Notch
on cable should face EXT SD connector – J8)

Backlight Cable – For backlight driver
board

Backlight driver board to backlight connector on the CPU
board (J14)

LVDS Cable – For LCD data

From LCD in bezel to CPU board (J11)

Speaker cable – For extending the speaker
connections

Speaker to speaker connector on the TVDRG2 backplane
board (J6)

Earth Braid – For strong ground
connection

From LCD bracket to the IO cards chassis

6 Pin Power Cable

Power Supply Board to Backplane Board (J10)

27. Connect all the cables as per the information in the above table and as shown in Figure 13.

Figure 13
Cables reconnected inside the
slant chassis plate

Summary of Contents for DR Graphic

Page 3: ...rd as shown in Figure 3 Separating the Bezel and Case Once all the cables are removed from the CPU board the next step is to separate the case from display bezel assembly 5 Close the door of the unit Figure 3 Processor board with all cables removed Figure 4 View of DR Graphic from hinge side ...

Page 4: ...circlips can be removed by pulling them out using a pair of needle nose pliers 7 Push out the hinge pin using a pointed tool like screw driver as shown in Figure 6 Once the hinge pins are pushed out by 5 to 7mm use a nose plier to pull the three hinge pins out of the hinges Figure 5 Positions of circlips Figure 6 Removing hinge pin ...

Page 7: ...9 Make sure that LCD backlight cable data cable and touch screen extension cable are routed to the right side below the LCD bracket step 20 Reconnect 18x 8 32 screws on LCD bracket See Figure 11 21 Reconnect the Earth braid on the LCD bracket 22 Put a spiral wrap around all the cables Figure 11 Reconnecting display bracket and routing cables on bezel side ...

Page 10: ...hown in red and green colour in Figure 14 are connected back 30 Reconnect the CJCs IO cabling and Power cable as required 31 Close the door 32 If the recorder has been removed from the panel secure it back into the panel using the mounting brackets Copyrighted Materials For more information please contact your supplier Figure 14 Reconnecting slant chassis IO card chassis ...