Honeywell DCP552 Mark II, User Manual

Page: 128 / 247

7-29
0 to 127
[Description:]
Ò----Ó is displayed for model without communications and
when
C97
is set to a value that is not equal to 0 and
setting cannot be performed.
When
C76
is set to 0, the communication function is not
activated.
0
C 76
76 Communication address
0: 9600bps
1: 4800bps
2: 2400bps
3: 1200bps
[Description:]
Ò----Ó is displayed for model without communications and
when
C97
is set to a value that is not equal to 0 and
setting cannot be performed.
0
C 77
77 Transmission rate
0: 8 bits, even parity, 1 stop bit
1: 8 bits, no parity, 2 stop bits
[Description:]
Ò----Ó is displayed for model without communications and
when
C97
is set to a value that is not equal to 0 and
setting cannot be performed.
0
C 78
78
Transmission code
0: CPL
1: ST221 (no PV trend)
2: ST221 (PV trend)
[Description:]
Ò----Ó is displayed for model without communications and
when
C97
is set to a value that is not equal to 0 and
setting cannot be performed.
0
C 79
79 Communication
0 : RS-485
1 : RS-232C
[Description:]
Ò----Ó is displayed for model without communications and
when
C97
is set to a value that is not equal to 0 and
setting cannot be performed.
0
C 80
80 Communication method
[Description:]
Can only be referenced for mechanical service use.
Ð
C 81
81
ROM ID
Ð
C 82
82 ROM ITEM
Ð
C 83
83 ROM revision
Ð
C 85
85 CPU board ID
Ð
C 86
86
I/O board ID
[Description:]
Ò-----Ó is displayed and setting cannot be performed.
----
C 87
87 Unused
----
C 88
88 Unused
----
C 89
89
Unused
1
C 90
90 PID type
0: Yes
1: No
0
C 91
91
PV1 burnout
0: Yes
1: No
0
C 92
92 PV2 burn out
0: Does not go on a second time off in time proportional cycle.
1: Goes on a second time in time proportional cycle.
0
C 93
93 Time proportional output
0: Does not go on a second time off in time proportional cycle
1: Goes on a second time in time proportional cycle
0
C 94
94 Time proportional output
Ð
C 84
84 Data version
Item code Item
No.
User
settings
Settings and descriptions
Factory default
settings
2 to 22mA
2 to 22mA
15
C 95
95
Voltage output control (CH1)
15
C 96
96
Voltage output control (CH2)
0 to 15
The backplate terminal is used when set to 0.
The loader jack is used for settings 1 to 15.
[Description:]
When set to 0, communications cannot be performed on
model without communications.
When set to 0, communications conditions are selected
using
C76
to
C80
.
The communication address is used for settings 1 to 15.
4800bps, 8 bits, even parity, 1 stop bit
0
C 97
97
Communications port
0 to 255
[Description:]
A setting of 0 is normally used.
0
C 98
98
Special function
0: Improved
1: Compatible with MarkI
Chapter 7. PARAMETER SETUP