6
7
PROGRAMMING THE CM907
b.
To adjust the period start time press the or buttons and ‘TIME 1 OK?’ will
be displayed. Holding the button down will change the time quickly.
Note:
If you are pressing the or buttons and the display flashes the next
change period, it means the next change will be pushed forward if you continue
to press or buttons).
c.
Press the green button to confirm the setting. ‘CHANGES SAVED’ is displayed
for 1.5 seconds then ‘SET TEMP 1’ will be shown.
Note:
If the original time setting did not require adjustment press the green
button to move on to step ‘
d.
’.
d.
The temperature setting for period
1
on Monday (MON) will now be flashing. To
adjust this press the or buttons and ‘TEMP 1 OK?’ will be displayed.
e.
Press the green
button to confirm the setting. ‘CHANGES SAVED’ will be
displayed for a moment followed by ‘SET TIME 2’.
f.
The next time and temperature period will now be active. Adjust this by repeating
steps
b - e
above until all 6 periods are set for Monday or move the slider switch
to the
AUTO
position to run the program as set, at any time.
g.
After setting period
6
‘CHANGES SAVED’ will be displayed as before, followed
by ‘DAY COMPLETE’.
You now have a choice of how to set the program for the next day:
h. To COPY the Monday’s program to another day:
Press the
COPY DAY
button to copy Monday’s program into Tuesday. The display
will go blank apart from ‘COPY MON TO’, indicating the program for Monday will
be copied to the selected target day, which is flashing in the top left corner of the
display. To select a different target day press the
DAY
button to cycle through the
days. Once the required day is flashing accept it by pressing the green button.
Note
: Once the target day is confirmed it becomes the day that is copied if the
COPY DAY
button is pressed again.
OR
To program a different day:
Press the
DAY
button to select the next day, which is displayed in the top left
corner of the display. The program for that day can then be adjusted by following
steps
b - g
above. Programs for the remaining days can be set in the same way,
using the
DAY
button to move to the next day.
