EN1H-1375GE23 R1014 - Translation of original
17
Honeywell GmbH
EN
8. Maintenance
8.1 Safety instructions for maintenance
Always observe the safety regualations and instructions.
Observe the instructions for working on the pumps.
8.2 Inspection
8.2.1 Buffer tank
1. Rinse the inlet to the buffer tank if necessary.
2. Rinse the tank and the integrated odour trap regularly.
3. Check the buffer tank as well as the shut-off valve and the floating switch.
- For this purpose, the floating switch holder can be pulled up out of the
tank.
- Make sure it locks properly back into place when returned to its position.
4. Check if the overflow is sealed and clean.
Maintenance should be performed by Honeywell technical staff.
• If necessary contact the service department at Honeywell.
Performance of tasks only by qualified personnel (see section 1.11).
Danger
Unintentionally switching on the compact booster unit
ª
Danger to life!
The compact booster unit has to be voltage free for all repairs
and maintenance work. Turning off the system with the motor
protection switch does not securely shut off the motor inlet lines.
Only perform maintenance work on the compact booster unit if
you are sure that the compact booster unit is free of power.
Secure the compact booster unit against being switched on
unintentionally.
Danger
Danger of injury from electric voltage.
ª
High shock currents and burns from direct and indirect contact with
live parts.
Turn off the power supply before maintaining the compact
booster unit and secure it from being turned on.
Warning
Components and lines under pressure
ª
Personal and property damage!
Before work is done on pressure-retaining components, the
pump has to be depressurised!
Disconnect the pump from the power supply!
Warning
Hot surfaces of the pump housing
ª
Danger of burning!
The pump housing has to be at ambient temperature!
Warning
Inappropriate lifting/moving of heavy modules or components
ª
Personal and property damage!
When moving heavy modules or components, use suitable
transport devices, lifting devices and lifting accessories.
Warning
Unqualified persons working on the compact booster unit
ª
Danger of injury!
Only let specially qualified personnel perfom repair and mainte-
nance work.
Warning
Using the pump after a fire/malfunction
ª
Functional disorder, danger of system malfunction!
Check the system thoroughly after operation during a fire.
Caution
Inappropriately maintained compact booster unit
ª
The proper function of the compact booster unit can no longer be
ensured!
Maintain the compact booster unit regularly.
Set up a maintenance schedule for the compact booster unit
that focuses especially on the pump lubrication, shaft seal and
clutch.
In case of damage, please contact our service department.
Setting up a maintenance schedule reduces the effort for maintenance
to a minimum and helps you avoid expensive repairs and you can work
on your compact booster unit reliably and without any problems.
To ensure that the compact booster unit can be operated reliably, the
required inspections have to be conducted on time.
Danger
Contamination of potable water
ª
Danger to life!
If the inlet line from the house connection to the buffer tank is
longer than 10x DN and/or the maximum volume is larger than
1.5l, then the inlet has to be rinsed at least once a week with
three times the pumped volume at a minimum flow rate of
0.2 m/s and a nominal width of over DN50 and 0.1 m/s at
anominal width of over DN50.
Setting the rinsing duration
Caution
Dirt in the system
ª
Damage to the pumps!
Rinse the tank before filling it.
Rinse the tank and the integrated odour trap regularly.