6
AutoCube 8200 User Guide
Prepare the Mounting Surface
Use the stand clamp as a template to trace and drill 4 holes (12 mm diameter) in
the mounting surface.
Note:
If the cables will exit through the bottom of the pole and through the mounting
surface, you must also drill the center hole of the stand clamp large enough to pull
the cable(s) through.
Adjust Stand Height
Stand height (H) is measured from the top of the stand to the top of the measure-
ment area or scale.
1. Loosen the screws on each side of the pole (4x) using an Allen wrench.
2. Slide the pole up to the desired height. Refer to the recommended
.
3. Tighten screws on each side of the pole to secure the pole.
4. Pull the camera cable out of the bottom of the pole until approximately 25 cm
(10 in) remain exposed at the top of the pole so it can be attached to the camera
later.
