Honeywell AlarmNet 7845GSM, Installation And Setup Manual

Page: 23 / 48

Section 3: Programming the 7845GSM
3-9
Refer to Table 5 for 4204 Emulation Mode programming and follow the prompts that pertain
to 4204 or Two-4204 mode. Check marks (
✔
)
indicate whether the prompt applies to that
mode.
Alternative Mode Programming
Press the [ENTER] key to begin programming
and f
ollow the prompts for the mode of
operation being programmed.
NOTE: The central station can remotely block access to
local device programming. If this has been done,
the following prompt appears:
Access to Prog
Mode Denied
Table 5: Programming a 7845GSM for Zone Trigger, 4204 Emulation, or Two-4204 Emulation modes.
PROMPTS
ZONE
TRIG.
4204/
2-4204
ENTRY OPTIONS DESCRIPTION
1
Strt Prog Mode?
(Y/N)_
✔ ✔
[Y], [N]
Enters programming mode.
2
Enter Password
✔ ✔
[0-9, A-F, N,
S, T, X, Y] If a password has been previously assigned, this
prompt appears.
Enter a 4-digit password (0-9, A-F, N, S, T, X, Y).
The next prompt appears.
3
Program 7845?
(Y/N)_
✔ ✔
[Y], [N] To begin programming the module, press [Y] and
go to Prompt 9: "Device Mode."
To create a password if none has been assigned,
press [N] and go to Prompt 4: "Create Password."
To change an existing password, press [N] and go
to Prompt 5: "Change Password."
4
Create Password?
(Y/N)_
✔ ✔ [Y], [N] Passwords can be used to protect account and
programming information.
If no password has been assigned, this prompt
appears after pressing [N] at the "Program 7845?"
prompt.
If a password is desired, press [Y] and go to Prompt
6: "Enter Password."
5
Change Password?
(Y/N)
✔ ✔
[Y], [N] If a password has already been assigned, this
prompt appears after pressing [N] at the "Program
7845?" prompt.
Press [Y] if you want to change the password.
NOTE: To clear an existing password, without
entering a new one, answer [Y] to the "Change
Password?" prompt, then press the [Enter] key
when prompted for the new password and its
confirmation.
6
Enter Password
✔ ✔
[0-9, A-F, N,
S, T, X, Y] If [Y] was pressed in Prompt 4 or 5, this prompt
appears.
Enter a 4-digit password (0-9, A-F, N, S, T, X, Y).
Re-enter the password as confirmation.
If the password doesn't match the first entry, the
following is displayed followed by the "Exit Prog.
Mode?" prompt:
7
✔ ✔ [0-9, A-F, N,
S, T, X, Y]
Verify Not OK
PSWD not created
Verify Password
Otherwise, the "Exit Prog. Mode?" prompt is
displayed directly.
WWW.DIYALARMFORUM.COM
WWW.DIYALARMFORUM.COM