Honeywell ADEMCO VISTA-12A, Installation And Setup Manual

Page: 65 / 112

Menu Mode Programming
5-9
PROMPT VALID ENTRIES EXPLANATION
L 01 02 03 04
T 23 22 21
23
Template Display
[
∗
] to continue
4. When [
∗
] is pressed, the selected template will
be displayed.
Top line of display represents loop numbers,
bottom line represents zone type assigned for
each loop.
5. Press [
∗
] to accept template.
PARTITION
1
Partition
1 = partition 1
2 = partition 2
3 = partition 3
[
∗
] to continue
6. Enter the partition in which the key is to be
active.
7. Press [
∗
] to continue.
ENTER START ZONE
00 = QUIT 36
Start Zone Number
[
∗
] to continue
8. The system will search for the highest
available consecutive 4-zone group (the four
zones in the case of the 5804 and 5804BD), and
display the lowest zone number of the group.
If you want to start at a different zone, enter
the zone desired, and press [
∗
]. If that zone
number is displayed, the system has the
required number of consecutive zones
available, beginning with the zone you
entered. If not, the system will again display a
suggested zone that can be used.
If the required number of consecutive zones is
not available at all, the system will display
“00”.
9. Press [
∗
] to accept.
INPUT S/N L
AXXX-XXXX –
Serial Number
[
∗
] to continue
10. Manually enter the serial number printed on
the label for the wireless key or press and
release the button to transmit its serial
number.
11. Press [
∗
] to accept the serial number. The
system will check for duplicate.
12. If necessary, press the [#] key to back up
without saving, and re-enter the serial
number.
Use the [A] key to move forward within the
screen, and the [B] key to move backward.