Honeywell ADEMCO VISTA-12A, Installation And Setup Manual

Page: 16 / 112

Installation and Setup Guide
2-10
4219/4229 Expansion Zones
1. Connect each module to the control’s keypad
terminals.
If power supervision is required, use the Trigger
Module terminals as described in the
Aux
Power Supervision Connections paragraph
in the Wiring to Keypads section (page 2-3).
2. Assign the module a device address of 08 using
its DIP switches. The device address determines
the zone numbers being used, as shown below.
Expander Module Addresses
Zones… Device Address…
17-24 08
3. Connect sensors to the module’s loops.
4. If using relays with the 4229, connect the
desired field wiring to the unit's relay contact
terminals.
Notes
•
Supports up to 8 expansion zones (NO or
NC) using 4219/4229 Zone Expander
Modules as follows:
•
Use 1000 ohm end-of-line resistors at the
end of loops connected to the 4219/4229
modules. (End-of line resistors used on the
control terminals are 2000 ohms.)
•
Expansion zones have normal response
time (400–500 msec), except zone
connected to each module’s loop “A,” which
can be set for fast response (10–15 msec).
BRN
GRN
BLK
(–) GROUND
RED
(+) 12VDC
YEL
4
3
2
1
ZONES
A
B C D
F
G H
DIP SWITCH
FOR SETTING ADDRESS
AND ZONE "A" RESPONSE
TAMPER JUMPER POSITION
4229 IN CABINET
(NOT TAMPER)
4229 REMOTE
(TAMPER PROTECTED)
TB1
4229
TB2
WHT
GR
Y
VIO
BLK YEL
ORG
NO NC C GND NO NC C
RLY
1
RLY
2
RELAYS OFF
RELAY
CONNECTOR
RELAY
2
RELAY
1
(TERM 6)
(TERM 4)
(TERM 5)
(TERM 7)
NO C NC
TERMINALS ON
CONTROL PANEL
1
2
3
4
DATA OUT (>)
TO CONTROL
DATA IN (<)
FROM
CONTROL
5
8
11
REED
(TAMPER)
SWITCH
2
E
1
3
4 6
7
9
10 12
TERMINATE EACH
PROGRAMMED ZONE
WITH 1000 OHM (1K)
END-OF-LINE RESISTOR
(EACH ZONE'S MAX.
LOOP RESISTANCE
300 OHMS + EOL)
4-PIN CONSOLE PLUG
EITHER OR BOTH CAN BE USED
4229-002-V0
Figure 7. Wiring Connections, 4219 & 4229 (4229 shown)