17
The Physical Keypad is used to
lock and unlock the door, and
program functions
If you have connected the lock to the Honeywell
Lock Application, the default Passcode “1234”
will no longer work; and you will have to use the
AP
from the App, which should be changed after
connecting (see Lock Settings step 3)
The time between inputs can be no longer than
3 seconds. After which the programming process
will be terminated.
In order to access the reset button, you must
remove the batteries to remove the screws
holding the interior assembly to the door.
Batteries must be installed to activate the reset
button.
1. TURN ON/OFF AUTO LOCK FUNCTION
a. Input the
AP
b.
- Green light and beep
c. 5
d.
e. Input time (20 - 900 seconds, and 00 to turn off)
f.
- Green light and beep
2. SOUND OFF
a. Input the
AP
b.
- Green light and beep
c. 6
d.
e. 1
f.
- Green light and beep
3. SOUND ON
a. Input the
AP
b.
- Green light and no beep
c. 6
d.
e. 2
f.
- Green light and beep
4. RESTORE FACTORY SETTINGS
a
.
Press the reset button on the PCB board until you hear one beep. Release, and then three seconds later
you will hear a second beep after three seconds. This indicates that the lock has been reset to the
Factory Settings. (Remove cover, The reset button is located inside the back panel, See image below)
b
.
The Administrator of the lock deletes the lock from the App (Must be done near lock)
Reset Button
OR
VERY IMPORTANT
PROGRAMMING PHYSICAL KEYPAD
Summary of Contents for 8832001S
Page 23: ...21 BACK OF TEMPLATE ...
