Security (cont'd)
15
If a user is so authorized, a TouchCenter or other keypad in one partition can be used to perform system functions in
another partition. (Note that only those partitions authorized and programmed by the installer can be accessed in
this manner.) To check the status of other partitions perform the following:
ICON
ACTION
NOTES
1.
Touch the
SECURITY
icon.
2.
Touch the "Current Partition" icon (lower
edge of the screen; in this case it displays
P1H
,
unless changed by installer).
This screen displays the available partitions and their current status.
The current partition is shown at the top of the display (P1). To change
this assignment, select the appropriate icon (e.g., touch P2 to switch
control to Partition 2).
3. Enter the code authorized to access other
partition(s).
If the code is accepted, the system displays the
partitions that user has access to.
Note: After leaving this screen when using a residential panel, the
selected partition in the TouchCenter automatically reverts back to the
TouchCenter’s home partition after two minutes. When using commercial
panels, you must select the TouchCenter’s home partition to return to it.
Fire and Carbon Monoxide Alarm Operation
Your fire alarm system and carbon monoxide detector (if installed) is on 24 hours a day, providing continuous
protection. In the event of an emergency, the installed smoke, heat, carbon monoxide detectors automatically send
signals to your Control/Communicator, triggering a loud interrupted sound from the keypad. An interrupted sound is
also produced by optional exterior sounders. EVACUATE ALL OCCUPANTS FROM THE PREMISES
IMMEDIATELY. Notify your Central Station/Security Company immediately and wait for further instructions.
UL
CO annunciation has not been investigated by UL and may not be used for UL installations.
In Case of Fire Alarm
1.
A FIRE message appears at your keypad and remains on until you silence the alarm.
2.
Should you become aware of a fire emergency before your detectors sense the problem, go to your nearest keypad
and manually initiate an alarm by touching the panic key assigned as FIRE emergency (if programmed by the
installer) and hold down for at least 2 seconds.
3.
Evacuate all occupants from the premises.
4.
If flames and/or smoke are present, leave the premises and notify your local Fire Department immediately.
Silencing and Clearing a Fire/Carbon Monoxide Alarm
1.
Silence, acknowledge, and clear the alarm by:
a.
For Residential Systems:
Touch “Touch here to Silence” on the display to silence the alarm.
For Commercial Systems:
Enter your code. This silences and acknowledges the alarm and the disarming
of the system (if armed).
