– 5 –
e.
Serial Number
| | | | | |
Serial Number
Loop
∗
56
Manually enter the 7-digit serial number printed on
the label of the transmitter.
Press the [
∗
] key to move to the “Loop” position,
and then enter the loop number.
To delete an existing serial number, enter 0 in the
loop number field. The serial number will change to
0's. If 0 was entered in error, simply re-enter the
loop number or press [#], the serial number will
return to the display.
Press [
∗
] to advance.
f.
Response Time
∗
56
Applies only to hardwire zones 1-8.
0
= 10mSec
1
= 350mSec
2
= 700mSec
3
= 1.2 seconds
Press [
∗
] to advance.
g.
Configuration
(Hardwire Type)
∗
56
Applies only to hardwire zones 1-8.
0
= EOL
1
= NC
2
= NO
3
= zone doubling (ZD) (V20P/V21iP only)
4
= double-balanced (DB) (V20P/V21iP only)
Press [
∗
] to advance.
h.
Library
(Zone Descriptor)
word 1
word 2
word 3
∗
82
For each descriptor word for this zone, enter the
3-digit number from the Vocabulary list.
(see Library list of descriptors on the back page or
in the controls’ Programming Guide)
Press [
∗
] to return to the Zone Number prompt to
program the next zone or advance to the Quit menu.
Menu 7: Quit Menu Mode Programming
NOTES:
Use this menu to exit Menu mode programming. After
exiting, the “Communicating” message appears
briefly, indicating the control is being updated with the
programmed information.
QUIT QUICK
PROGRAMMING MODE
1 – Exit – Allow Re-entry
2 – Exit – Block Re-entry
3 – Back to 1st Page
Quit Menu
Programming Option
Entries
Field
Notes
a.
Exit – Allow Re-Entry
1
∗
99
Exits program mode and allows
re-entry by:
Installer Code + 8 0 0, or pressing [
∗
] and [#] at the
same time within 50 seconds of powering up
b.
Exit – Block Re-Entry
2
∗
98
Exits programming mode and prevents re-entry by:
Installer Code + 8 0 0.
To reenter programming mode, the system must be
powered down, then powered up. Then press [
∗
]
and [#] at the same time within 50 seconds of
powering up.
For other
∗
98 program mode lockout options, see
field
∗
88 in
standard control panel programming
mode (installer code + 800).
c.
Back to 1st Page
3
--
Press 3 to return to the first page of Menu mode
programming.
