Home and Office Security Safes
5
8
Step 2 - Install Safe
Once safe has been placed into position in the wall cutout,
secure into place by screwing 4 wood screws (included) through
the four recessed holes in the front flange of Safe and into studs.
Tighten screws flush with flange.
3. Select the expandable shelf extensions that will work best with
the depth of the installed safe and using small screws and nuts,
secure into place.
1. Install your wall safe into the wall cutout so that the hinge side of the safe is
flush against the right hand stud and the front flange is flat against the wall.
With the safe door open, extend the telescoping back by pushing it from
the inside until maximum possible depth is achieved. Once the back is
extended, install six wood screws (included) through the pre-drilled holes in
right hand side of safe and into stud. Tighten safe flush to stud. Do not over
tighten screws.
2. Now install six screws (included) through the pre-drilled holes in left hand side
of safe and into stud. Do not over tighten.
NOTE: There may be a slight amount of space between the safe side wall
and the left hand stud, this is normal. The right hand hinged side of your wall
safe must be tightened flush to the right hand stud.
Checking, Changing and Installing
New Batteries
Your new safe arrived with 4-AA batteries pre-installed at the factory. It is important
to periodically check the batteries and, if necessary, replace with a new set.
Checking Batteries
1. Locate the B key on the keypad and press.
2. If the yellow LED flashes and you hear a beep, the batteries
are good.
3. If the red LED flashes, change the batteries within two
months.
4. If the LED does not light, then you must replace the
batteries immediately.
5. Proceed to Changing and Installing New Batteries.
Changing and Installing New Batteries
1. Using your personal Passcode or Emergency Override
Key, open the safe door and locate the battery
compartment on the back of the door.
2. Press firmly in on the right side of the battery compartment
cover and slide to the left to open.
3. Remove the 4 old batteries and replace with 4 new
Alkaline “AA” batteries. Make sure that they are installed
in the proper direction as illustrated on the battery
compartment interior.
4. Replace the cover and, prior to closing, test your
Passcode as instructed o
n page 6.
NOTE: Proper disposal of discharged batteries is encouraged!
Important:
Replacing the batteries will not erase your personal Passcode from memory. However,
weak or dead batteries will prevent the use of the digital key pad. Access to the safe
will have to be made using the Emergency Override Key.
(See page 7).
Installing Your Wall Safe
B
0
8 9
7
A
6
5
2 3
1
4
Yellow
Light
Red
Light
Battery
Cover
