INNCOM E7 THERMOSTAT USER GUIDE
19
36-00013—02
WINDOW SENSOR TEST
1.
Enter SERVICE MODE.
2.
Use the UP/DOWN arrow buttons to select
WIn
.
3.
Press MODE to begin the test. When the window switch opens (window
is open), the e7 emits an audible beep and the display shows a count of the
number of times the window status changes from closed to open.
If there is no audible beep, then double check the window sensor wiring.
4.
Press
o
F|
o
C twice to exit service mode.
WIDE AREA NETWORK (WAN) TEST
NOTE:
This test is only required when the e7 is wired or wireless connected to the
INNControl 3 server in a networked energy management system.
The WAN Test verifies the wireless RF or wired RS485 network connection
with the INNControl 3 server.
1.
Enter SERVICE MODE.
2.
Use the UP/DOWN arrow buttons to select
WAn
.
3.
Press MODE to begin the test. This test invokes a command from the
INNControl 3 server to scroll the Room ID across the display.
If the proper ROOM ID does not scroll across the display, then it is likely
the INNControl 3 server is not setup, or the RF channel, RF PAN, or RoomID of the e7 is set incorrectly.
If in a wired configuration, check the RS485 wiring.
4.
Press
o
F|
o
C twice to exit service mode.
RELATIVE HUMIDITY TEST
NOTE:
The e7 thermostat only displays the measured relative humidity in
SERVICE MODE.
1.
Enter SERVICE MODE.
2.
Use the UP/DOWN arrow buttons to select
rH
.
3.
Press MODE to display the relative humidity percentage.
4.
Press
o
F|
o
C twice to exit service mode.
HVAC CONTROL TEST
1.
Once in normal operating mode, the thermostat displays the set and mea-
sured temperature, and the current operating mode.
2.
Using the UP/DOWN arrow, increase or decrease the temperature by 3-4
degrees. Listen for the on-board relays to engage, and for the HVAC fan
to turn on. Verify the HVAC system is reaching the set temperature.
