Honeywell Home R200ST-N1, Installation And User Manual

Page: 9 / 96

- 9 -
9. Visual & acoustic signals
Operating mode Visual signal(flash) Acoustic signal(beep) Description
Normal 1 x per 48 seconds None Device is functioning properly
Test 1 x per second (4 x) 1 x per second (3 x) /
pause of 1,5 seconds Device is testing by press the
test/silence button for 3
seconds
Alarm for smoke 1 x per second (4 x) 1 x per second (3 x) /
pause of 1,5 seconds Device is detecting smoke
Alarm silence 1 x per 8 seconds None If the Alarm signal is muted,
lasting for approx. 10 minutes
Low battery warning 2 x per 48 seconds 1 x per 48 seconds Battery is running low, replace
the smoke detector with a new
one.
Low battery/Sensor
fault warning silence 1 x per 48 seconds None If Low battery/Sensor fault
warning is muted, lasting for
approx. 8-10 hours
Sensor fault warning 2 x per 48 seconds None Sensor is not functioning
properly, see 11. Maintenance
Interconnected
alarm None 1 x per second (3 x) /
pause of 1,5 seconds Device received remote alarm
from other device.
End of life warning 3 x per 48 seconds 3 x per 48 seconds The device is end of life,
replace the smoke detector
with a new one.
Wireless
interconnecting Continuously on None Device is sending or searching
for wireless signal
HOW TO MUTE ALARMSOUND
Alarm/Low
battery/Sensor
fault silence ONLY AFTER RECOMMENDED ACTIONS HAVE
BEEN TAKEN
Press cover test/silence
button for 3 seconds
If the alarm fails to operate or you have a "fault warning" the advice of the manufacturer
should be sought.
10. Wireless functions
(see page 5)
Interconnect your alarms
a) Place the interconnected alarms as close as possible, not further than 5 meters apart.