3-30
2) Tighten the special adjusting bolt.
Tighten the 8 mm flange nut and the 10 x 80 mm flange bolt
in this order to the specified torque.
TORQUE:
8 mm flange nut: 26 N.m (2.7 kgf.m, 20 lbf.ft)
10 x 80 mm flange bolt: 44 N.m (4.5 kgf.m, 33 lbf.ft)
3) After tightening the nut and bolt to the specified torque,
check the belt tension and deflection (P. 3-29).
4) Install the silencer duct assembly (P. 3-11 and 12).
Install the engine cover (P. 4-2).
[1]
8 mm FLANGE
NUT
[2] SPECIAL
ADJUSTING
BOLT
[3] ALTERNATOR
ASSEMBLY
10 x 80
[1]
ALTERNATOR
BELT
[2] CRANKSHAFT
PULLEY
[3] ALTERNATOR
PULLEY
3) Remove the alternator belt by removing it from the
alternator pulley first, then from the crankshaft pulley.
• Do not contaminate the alternator belt with oil or grease.
• Do not bend the alternator belt. Store the belt by hanging
it on the wall.
Installation:
1) Install a new alternator belt on the crankshaft pulley first,
then install the other end of the belt on the alternator
pulley.
Do not turn the crankshaft pulley counterclockwise.
NOTICE