Honda HRX217K6HYA, Manual

Page: 8 / 169

2-1
2. SERVICE INFORMATION
1. SERVICE RULES
• Use Honda Genuine parts or their exact equivalent. Lower quality parts can damage the mower or reduce its
performance.
• Install new gaskets, O-rings, and seals during reassembly.
• This mower uses metric fasteners and SAE (nonmetric) fasteners. Metric bolts, nuts, and screws are not
interchangeable with nonmetric fasteners. The use of incorrect tools and fasteners may damage the mower.
• When tightening nuts and bolts, begin with the larger-diameter or inner bolts, and tighten diagonally to the
specified torque values, unless a particular tightening sequence is specified.
• When tightening self-tapping screws, be especially careful to avoid cross-threading or overtightening.
• Clean parts in nonflammable solvent after disassembly.
• Lubricate sliding surfaces before reassembly.
• After reassembly, check parts installation and operation.
2. SYMBOLS USED IN THIS MANUAL
As you read this manual, you may find the following symbols with the instructions.
1. SERVICE RULES . . . . . . . . . . . . . . . . . . . . .
2-1
6. TOOLS . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2-5
2. SYMBOLS USED IN THIS MANUAL . . . . .
2-1
7. TROUBLESHOOTING . . . . . . . . . . . . . . . . .
2-7
3. SERIAL NUMBER LOCATIONS . . . . . . . . .
2-2
8. TROUBLESHOOTING TECHNIQUES . . .
2-12
4. SERVICE SPECIFICATIONS . . . . . . . . . . . .
2-3
9. CABLE ROUTING AND TIES . . . . . . . . . .
2-26
5. TORQUE VALUES . . . . . . . . . . . . . . . . . . . .
2-4

A special tool is required to perform the procedure.
(commercially
available)
Commercially available tools are distinguished by the words (commercially available). They
are not available through the American Honda Parts Department. Most commercially available
tools shown in this shop manual can be ordered through the Tool and Equipment program by
calling (888) 424-6857. Refer to the Tool and Equipment program catalogue for a complete
tool listing.

Apply grease.
(Extreme pressure NLGI #2 GC-LB grease or equivalent, or unless otherwise specified)

Apply engine oil unless otherwise specified.
O x O (O) Indicates the diameter, length, and quantity of metric flange bolts used.
P. O-O Indicates the reference page.