Honda 3755790, Operator'S Manual

Page: 5 / 12

1.
Install the plow on the tractor:
Secure
the
link pins to the lower
links
with spring
pins. Install the hitch upper link at the top
hole in the mast and secure with the hitch
2. Working on flat ground,
raise
the left side
of the tractor
-
and block at this
(This
simulates
a
plowing
position-right tractor tires in furrow
wall,
left tires on land.)
3.
Raise
and lower the plow with the
hydraulic
lift;
the plow bottom should
contact the ground with the lift lever in
the lowered or “float” position.
Next,
raise
the plow slightly
off
the ground
and adjust the upper and lower links so
the plow bottom is completely level with
the ground. Place! the hitch in the float
position and check the plow bottom:
it
should rest on the ground.
Finally, adjust the upper link slightly so
the landside heel
is
approximately off
the ground.
4.
Align the plow directly behind the tractor
(upper link extended straight toward rear).
With a straightedge
(2 x 4,
steel bar,
extend a line from the inside edge of the
right rear tire on back to the plow bottom.
(This
simulates a furrow For the
plow to cut wide (standard width). the.
bottom should reach this line.
To increase or decrease the standard
cutting width, see
PLOW
ADJUSTMENTS
on the next page.
5. Set
the gauge wheel approximately
above the ground. This
will
provide a
controlled plow depth and prevent the
plow from going too deep in soft and/or
wet spots.