Honda 3755790, Operator'S Manual, Page: 4 / 12

7.
Insert the standard into the hub on the
and secure it with the pin. Leave an
equal amount of the pin extending on
each side
of
the hub.
8. Assemble the coulter blade hub to the
blade using three carriage bolts, flat
SPACERS NUTS
washers, hex lock
9.
Assemble the fork and coulter with the
axle, aligning the squares. Install two flat
washers. and secure with the cotter pin.
Bend the legs of the pin over the axle.
10. Mount the assembly on the
left side of the plow beam using the
clamp and U-bolt. Insert two spacers
between the beam
arms,
then secure the
U-bolt with hex nuts: tighten the nuts
securely.
After assembly, refer to
to set the coulter.
1 1. Install the hub on the gauge wheel using
three
x
bolts, plain
washers, and hex lock nuts.
12.
Install the flat washer on the hex bolt,
insert the bolt through the hub. then add
a second flat washer
and
the hex
j a m
nut.
Secure with the lock washer and hex nut
on the inside of the bracket
as
shown.
13.
Mount the gauge wheel assembly on the
plow beam standard using the short
U-bolt and secure with
lock washers
and
hex
nuts.
Preparing
Plow
for
Use
After assembly, clean the moldboard with a
rag
soaked in turpentine, kerosene or
naphtha
so
that
dirt will
be
less
likely to stick
to the protective coating. The coating can be
removed with an old brick or
a pumice stone,
but this usually isn't unless the
soil
is
too wet or
Work in a area
and
handle cleaning materials
with
care.
Wipe
up any liquid immediately
and
make
sure the
area is
before starting the
tractor.
SPACERS NUTS
BLADE
WASHER
HEX BOLT
WASHERS
BR
ACKET
LOCK WASHERS,