Honda 2003-2005 PILOT, Installation Instructions Manual

Page: 3 / 7

© 2004 American Honda Motor Co., Inc - All Rights Reserved. AII 28061 (0409)
3 of 7
6. Remove four self-tapping screws that fasten the
center panel.
7. Pull the center panel out toward you to release the
two clips. Unplug the vehicle connectors from the
accessory socket, and remove the center panel.
8. Remove four screws that fasten the left and right
vehicle brackets. Pull the heater control unit and
pocket out toward you, and unplug the vehicle
connector.
9. Remove the left and right vehicle brackets (six
self-tapping screws), separate the heater control
unit from the pocket. Set the pocket aside; it will
not be reused.
SELF-
TAPPING
SCREW
LEFT
VEHICLE
BRACKET HEATER
CONTROL UNIT
POCKET
RIGHT
VEHICLE
BRACKET
SELF-
TAPPING
SCREW
SELF-
TAPPING
SCREW
(Reuse.)
SELF-
TAPPING
SCREW
(Reuse.)
10. Install the DIN bezel to the in-dash CD changer.
Set the heater control unit on the CD changer,
attach the left and right vehicle brackets using the
two self-tapping screws removed in step 9 and
four 5 x 8 mm washer-screws included in the
in-dash CD changer kit.
NOTE: When installing the cassette player and
the in-dash CD changer, the changer is installed in
the center panel opening, and the cassette player
is installed in the audio unit opening.
SELF-
TAPPING
SCREW
(Reuse.)
5 x 8 mm
WASHER
SCREW
5 x 8 mm
WASHER
SCREW
RIGHT
VEHICLE
BRACKET
LEFT
VEHICLE
BRACKET
CD CHANGER
HEATER
CONTROL
UNIT
DIN BEZEL
SELF-
TAPPING
SCREW
(Reuse.)
RIGHT
VEHICLE
BRACKET
SCREW
(Reuse.)
HEATER
CONTROL UNIT
VEHICLE
CONNECTOR
POCKET
LEFT
VEHICLE
BRACKET
CLIPS (2)
VEHICLE
CONNECTOR
CENTER
PANEL
SELF-TAPPING
SCREW