4 of 7
AII 42259 (0908)
© 2009 American Honda Motor Co., Inc. – All Rights Reserved.
7.
Insert one 6 x 16 mm hex bolt into the hole in the left
trunk side panel, and install two 6 mm plain washers
and a 6 mm flange nut. Torque the 6 x 16 mm hex
bolt to 9.8 N·m (7.2 lb-ft).
8.
Install a 6 x16 mm hex bolt to the hole in the right
side panel the same way.
9.
Using a pushpin, pierce the center of the circle of
dots on the inside of the left trunk side trim panel.
10. While wearing eye protection, drill at the pierced
mark to 11 mm. First drill with a 3 mm bit, and
finish with an 11 mm drill bit.
11. Repeat steps 9 and 10 to mark and drill the right
trunk side trim panel.
HEX BOLT, 6 x 16 mm
Torque to 9.8 N·m
(7.2 lb-ft).
2 PLAIN
WASHERS,
6 mm
FLANGE NUT,
6 mm
LEFT TRUNK
SIDE PANEL
HOLE
2 PLAIN
WASHERS
6mm
722004CE
PUSHPIN
MARK
DRILL
DRILL BIT
(3 mm 11 mm)
LEFT TRUNK
SIDE TRIM
PANEL
12. Assemble four small anchors.
13. Install a spacer on the two of the assembled
anchors. Note the direction of the spacer.
761811AE
STUD BOLT
SMALL ANCHOR
740231AE
SPACER
STUD BOLT
SMALL ANCHOR
